UBCD4Win Forums: Partition Lost After Using Ubcd4Win - UBCD4Win Forums

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Partition Lost After Using Ubcd4Win

#1 User is offline   spronin Icon

  • Newbie
  • Pip
    • Group: Members
    • Posts: 3
    • Joined: 15-November 09

    Posted 15 November 2009 - 10:24 AM

    I downloaded, build & burnt an ISO. Restarted and boot from the CD to test it. Seemed to work for what I need, aside from a lot of "missing x.dll" popups. Took it out and restarted to find my 4TB Raid Array I had on drive X: to be gone, now says the partition is gone. >.< What do I do now?
    0

    #2 User is offline   bengt Icon

    • Skeptic
    • PipPipPipPipPipPip
      • Group: Donator/Beta Tester
      • Posts: 1,261
      • Joined: 16-December 05
      • Gender:Male
      • Location:Bork, bork, bork

      Posted 15 November 2009 - 02:15 PM

      Reinstall Windows
      0

      #3 User is offline   mbarnes Icon

      • Ultimate Member
      • PipPipPipPipPip
        • Group: Members
        • Posts: 506
        • Joined: 13-November 05

        Posted 15 November 2009 - 05:53 PM

        Hi spronin

        unless you have NT 4 on your PC then ubcd4win does not change anything on the hard disk without you taking some action.
        [NT 4 is unlikely with such a big hard disk.]

        presumably the RAID controller has diagnostics which can check the raid & disks are working correctly before going to check for software corruption
        (Note you would not expect 'a lot of "missing x.dll" popups'. if ubcd4win was built correctly)

        what you do next depends on how good your backup system is.
        If no backup available find an expert to help you

        regards
        Mike Barnes
        0

        Page 1 of 1
        • You cannot start a new topic
        • You cannot reply to this topic

        1 User(s) are reading this topic
        0 members, 1 guests, 0 anonymous users