Hi. I received these error while trying to build the .iso. Can someone help me figure out how to get rid of them? I kept them in the groupings that I received them in. Every space means that the errors appeared somewhere else in the log. Thanks.

"Error: SetupIterateCabinet returned 13: The data is invalid."
"Error: fileCopy() failed"

Error: CreateFile "C:\pebuilder313\BartPE\i386\inf\netmscli.inf" returned error 2: The system cannot find the file specified.
Error: fopen "C:\pebuilder313\BartPE\i386\inf\netmscli.inf" returned error 2: The system cannot find the file specified.
Error: delLine() failed
Error: doInfAppend() file="C:\pebuilder313\pebuilder.inf" failed

Error: CreateFile "C:\pebuilder313\BartPE\Programs\Nu2Menu\nu2menu.xml" returned error 2: The system cannot find the file specified.

Error: fopen "C:\pebuilder313\BartPE\Programs\FileRecovery\filerecovery_nu2menu.xml" returned error 2: The system cannot find the file specified.
Error: appendFile() failed

Error: fopen "C:\pebuilder313\BartPE\Programs\sysclean\sysclean_nu2menu.xml" returned error 2: The system cannot find the file specified.
Error: appendFile() failed

I got my .iso made and mounted but when I go to run my computer off of the cd I get the message:

winlogon.ese - Entry Point Not Found
The procedure entry point UninitializeCriticalSection could not be located in the dynamic link library KERNEL32.dll.

I get this message when is loads the Windows background up. After I click ok on the error message it just stays at this screen. Any ideas what I could do to fix this? Do I need a new kernel32.dll file?

Thanks

Hi

What operating system are you using?

What version of BartPE are you using to create the ISO.

What are the exact / full file names that you downloaded?

Have you selected "Burn to CD" from Bart PE Builder? If no, change your CD writing software and try again.