Every time I try and run the netwrok configurator and map a drive to another pc I get a error then the program network configirator shuts down.. It recognizes my network card at first.. Intel pro 100 but once it shuts down and I reopen it to try and set up networking again it says unable to laod driver no device found.. why is this... thanks,...

witch drivers do you use ?
may be this can help you:
http://www.911cd.net/forums//index.php?sho...l=intel+pro+100

Joshua

using version 2.55 with driver pack 1.6 thansk

Have you tried using the BTS 1.01 drivers? Thanks.

ok I downloaded the BTS and run it.. now I have a folder with a few new directories in it that I cant make heads or tails of..insight needed please.. thanks..

Did you follow the instructions for installing the new BTS drivers located here in the forums? They work different than the "old" 1.6 ones. Also, I think there was something we found a while back about a similar problem with PE Network Configurator. I have to find where that topic is as there was a fix to get around it.

ok got new pe.iso setup with BTS drivers installed properly.. tried this ona different machine and same error.. initalizes everything and maps drives for me but when I hit apply to apply the settings so I can get out of the pe configurator it errors out something about failed to initialize network adapter or somethign to that extent. I have this error on a intel pro 100 and now a broadcom 440x 10/100 adapter.. both are onboard adapters.. I can get the broadcom to work with a netboot dos disk no problem but not the intel.. but theres also a wireless card on the laptop that the intel card is integrated on... thanks...

Did you try disabling the "911" plugins?

how do I go about that ??? thanks,, for helping me throguh this..

1. start pebuilder.exe
2. push button Plugins
3. disable 911EXP: EventLog and MMC EventLog Viewer plugin
4. disable 911EXP: MMC plugin
5. build your iso again, and try if it now works.

Joshua

Actually only the "MMC: Eventlog Viewer" plugin needs to be disabled. A lot of users have confirmed this in the forum and with me personally via email.

did as you suggested and with help on how to go about doing so from the others here it worked.. thanks guys... love this project and its always getting better...