i used a pro cd and made everything on a machine w/ pro but intended on using it on a faulty machine w/ home. will this still work?

YES

As long as the faulty system has enough of the system requirements to run XP, you should be fine.

Hi I2ISSE

If you test your Bart PE /UBCD4Win disk on the PC it was built on and it works, then the only things which would stop it booting on a PC with XP Home and seeing the hard disk is a hard disk with physical damage or corrupted partition sector or the PC has a RAID or SATA hard disk controller requiring drivers.
( press F6 and supply driver floppy disk at bootup)

With default build minimum ram required is about 128Meg

regards
Mike Barnes

PreShell will be in the next release of the project so we should be able to boot on a system with only 64Megs!!

And maybe even 32MB! (well, maybe...)

I'm not sure the word "run" would apply if it did boot with just 32Mb...

for three days i was able to rescue data from a notebook with 48MB-ram
with ubcd4win and PreShell! but 32mb is not enough !!!

Joshua

48MB! Sounds good to me!

Bring it on!